Cisco Nexus 7000 Series - Show Ip Dhcp Relay Address

show ip dhcp relay address
To display DHCP server addresses configured on the device, use the show ip dhcp relay address command.
show ip dhcp relay address [interface {ethernet list| port-channel list}]
show ip dhcp relay address [interface interface-list]
Syntax Description
(Optional) Restricts the output to a DHCP addresses
configured on range or set of Ethernet or port-channel
interfaces and subinterfaces.
interface
(Optional) Restricts the output to a DHCP addresses
configured on range or set of Ethernet interfaces and
subinterfaces.
ethernet
Single interface, range of interfaces, or
comma-separated interfaces and ranges (see the
“Examples” section).
list
(Optional) Restricts the output to a DHCP addresses
configured on range or set of port-channel interfaces
and subinterfaces.
port-channel
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
Support was added for the interface keyword and for VRF awareness.5.0(2)
This command was introduced.4.2(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display all the DHCP relay addresses configured on a device:
switch# show ip dhcp relay address
Interface Relay Address VRF Name
------------- ------------- --------
Ethernet1/2 10.1.1.1
Cisco Nexus 7000 Series Security Command Reference
795
Show Commands
show ip dhcp relay address