Cisco Nexus 7000 Series - Show Cts Role-Based Sgt-Map

show cts role-based sgt-map
To display the global Cisco TrustSec Security Group Tag (SGT) mapping configuration, use the show cts
role-based sgt-map command.
show cts role-based sgt-map [summary| sxp peer peer-ipv4-addr| vlan vlan-id| vrf vrf-name]
Syntax Description
(Optional) Displays a summary of the SGT mappings.summary
(Optional) Displays the SGT map configuration for
a specific SGT Exchange Protocol (SXP) peer.
sxp peer peer-ipv4-addr
(Optional) Displays the SGT map configuration for
a specific VLAN.
vlan vlan-id
(Optional) Displays the SGT map configuration for
a specific virtual routing and forwarding (VRF).
vrf vrf-name
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
The summary, sxp peer peer-ipv4-addr, vlan vlan-id, and vrf vrf-name
keywords and arguments were added.
6.2(2)
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to display the Cisco TrustSec SGT mapping configuration:
switch# show cts role-based sgt-map
IP ADDRESS SGT VRF/VLAN SGT CONFIGURATION
5.5.5.5 5 vlan:10 CLI Configured
5.5.5.6 6 vlan:10 CLI Configured
5.5.5.7 7 vlan:10 CLI Configured
5.5.5.8 8 vlan:10 CLI Configured
10.10.10.10 10 vrf:3 CLI Configured
Cisco Nexus 7000 Series Security Command Reference
752
Show Commands
show cts role-based sgt-map