Cisco Nexus 7000 Series - Time-Range

time-range
To configure a time range, use thetime-range command. To remove a time range, use the no form of this
command.
time-range time-range-name
no time-range time-range-name
Syntax Description
Name of the time range, which can be up to 64
alphanumeric, case-sensitive characters.
time-range-name
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
You can use a time range in permit and deny commands for IPv4 and IPv6 ACLs.
Examples
This example shows how to use the time-range command and enter time range configuration mode:
switch# configure terminal
switch(config)# time-range workweek-vpn-access
switch(config-time-range)#
Related Commands
DescriptionCommand
Specifies a time range that has a specific start date
and time.
absolute
Configures an IPv4 deny rule.deny (IPv4)
Configures an IPv6 deny rule.deny (IPv6)
Specifies a time range that is active one or more times
per week.
periodic
Cisco Nexus 7000 Series Security Command Reference
962
T Commands
time-range