dot1x system-auth-control
To enable 802.1X authentication, use the dot1x system-auth-control command. To disable 802.1X
authentication, use the no form of this command.
dot1x system-auth-control
no dot1x system-auth-control
Syntax Description
This command has no arguments or keywords.
Command Default
Enabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
The dot1x system-auth-control command does not delete the 802.1X configuration.
You must use the feature dot1x command before you configure 802.1X.
This command does not require a license.
Examples
This example shows how to disable 802.1X authentication:
switch# configure terminal
switch(config)# no dot1x system-auth-control
This example shows how to enable 802.1X authentication:
switch# configure terminal
switch(config)# dot1x system-auth-control
Related Commands
DescriptionCommand
Enables the 802.1X feature.feature dot1x
Displays 802.1X feature status information.show dot1x
Cisco Nexus 7000 Series Security Command Reference
205
D Commands
dot1x system-auth-control
To Next Page
Loading...
