Cisco Nexus 7000 Series - Show Ip Arp Inspection

show ip arp inspection
To display the Dynamic ARP Inspection (DAI) configuration status, use the show ip arp inspection command.
show ip arp inspection
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the status of the DAI configuration:
switch# show ip arp inspection
Source Mac Validation : Enabled
Destination Mac Validation : Enabled
IP Address Validation : Enabled
Vlan : 1
-----------
Configuration : Enabled
Operation State : Active
ARP Req Forwarded = 0
ARP Res Forwarded = 0
ARP Req Dropped = 0
ARP Res Dropped = 0
DHCP Drops = 0
DHCP Permits = 0
SMAC Fails-ARP Req = 0
SMAC Fails-ARP Res = 0
DMAC Fails-ARP Res = 0
IP Fails-ARP Req = 0
IP Fails-ARP Res = 0
Related Commands
DescriptionCommand
Enables DAI for a specified list of VLANs.ip arp inspection vlan
Displays the trust state and the ARP packet rate for
a specified interface.
show ip arp inspection interface
Cisco Nexus 7000 Series Security Command Reference
782
Show Commands
show ip arp inspection