radius-server retransmit
To specify the number of times that the device should try a request with a RADIUS server, use the radius-server
retransmit command. To revert to the default, use the no form of this command.
radius-server retransmit count
no radius-server retransmit count
Syntax Description
Number of times that the device tries to connect to a
RADIUS server(s) before reverting to local
authentication. The range is from 1 to 5 times.
count
Command Default
1 retransmission
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the number of retransmissions to RADIUS servers:
switch# configure terminal
switch(config)# radius-server retransmit 3
This example shows how to revert to the default number of retransmissions to RADIUS servers:
switch# configure terminal
switch(config)# no radius-server retransmit 3
Related Commands
DescriptionCommand
Displays RADIUS server information.show radius-server
Cisco Nexus 7000 Series Security Command Reference
609
R Commands
radius-server retransmit
To Next Page
Loading...
