Cisco Nexus 7000 Series - Capture Session

capture session
To enable a capture session for the access control list (ACL), use the capture session command.
capture session session
Syntax Description
Session ID. The range is from 1 to 48.session
Command Default
None
Command Modes
ACL capture configuration mode (config-acl-capture)
Command History
ModificationRelease
This command was introduced.5.2(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure an ACL capture session configuration:
switch# configure terminal
switch(config)# ip access-list abc1234
switch(config-acl)# capture session 7
switch(config-acl)#
Related Commands
DescriptionCommand
Creates an access list.ip access-list
Configures an ACL capture session.monitor session session type acl-capture
Cisco Nexus 7000 Series Security Command Reference
64
C Commands
capture session