Cisco Nexus 7000 Series - Show Startup-Config Aclmgr

show startup-config aclmgr
To display the user-configured access control lists (ACLs) in the startup configuration, use the show
startup-config aclmgr command.
show startup-config aclmgr [all]
Syntax Description
Displays both the default (CoPP-configured) and
user-configured ACLs in the startup configuration.
all
Command Default
None
Command Modes
Any
Command History
ModificationRelease
This command was introduced.5.2(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the user-configured ACLs in the startup configuration:
switch(config)# show startup-config aclmgr all
!Command: show startup-config aclmgr all
!Time: Wed May 25 08:04:36 2011
!Startup config saved at: Mon May 23 05:44:16 2011
version 5.2(1)
ip access-list acl1
ip access-list copp-system-p-acl-bgp
10 permit tcp any gt 1024 any eq bgp
20 permit tcp any eq bgp any gt 1024
ipv6 access-list copp-system-p-acl-bgp6
10 permit tcp any gt 1024 any eq bgp
20 permit tcp any eq bgp any gt 1024
ip access-list copp-system-p-acl-cts
10 permit tcp any any eq 64999
20 permit tcp any eq 64999 any
ip access-list copp-system-p-acl-dhcp
10 permit udp any eq bootpc any
20 permit udp any neq bootps any eq bootps
ip access-list copp-system-p-acl-dhcp-relay-response
10 permit udp any eq bootps any
20 permit udp any any eq bootpc
ip access-list copp-system-p-acl-eigrp
10 permit eigrp any any
ip access-list copp-system-p-acl-ftp
10 permit tcp any any eq ftp-data
20 permit tcp any any eq ftp
Cisco Nexus 7000 Series Security Command Reference
897
Show Commands
show startup-config aclmgr