Cisco Nexus 7000 Series - Identity Policy

identity policy
To create or specify an identity policy and enter identity policy configuration mode, use the identity policy
command. To remove an identity policy, use the no form of this command.
identity policy policy-name
no identity policy policy-name
Syntax Description
Name for the identity policy. The name is case
sensitive, alphanumeric, and has a maximum of 100
characters.
policy-name
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to create an identity policy and enter identity policy configuration mode:
switch#configure terminal
switch(config)# identity policy AdminPolicy
switch(config-id-policy)#
This example shows how to remove an identity policy:
switch#configure terminal
switch(config)#no identity policy AdminPolicy
Related Commands
DescriptionCommand
Displays identity policy information.show identity policy
Cisco Nexus 7000 Series Security Command Reference
369
I Commands
identity policy