cts role-based monitor
To configure RBACL monitor, use the cts role-based monitor command. To revert to the default, use the
no form of this command.
cts role-based monitor {all| enable| permissions from| {sgt| unknown }| to | {dgt| unknown}}[ ipv4 | ipv6
]
no cts role-based monitor {all| enable| permissions from| {sgt| unknown }| to | {dgt| unknown}}[ ipv4 |
ipv6 ]
Syntax Description
Enables monitoring permissions for all source groups
to all destination groups.
all
Enables RBACL monitor mode.enable
Specifies the range for the SGT and DGT that needs
to be monitored.
permission
Specifies any SGT.
sgt
Specifies the Specifies the destination SGT.
dgt
Specifies an unknown SGT.unknown
Specifies the IPv4 protocol version.ipv4
Specifies the IPv6 protocol version.ipv6
Command Default
Disabled
Command Modes
Global configurationVRF configuration
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
Cisco Nexus 7000 Series Security Command Reference
167
C Commands
cts role-based monitor
To Next Page
Loading...
