Cisco Nexus 7000 Series - Show Hardware Rate-Limiter

show hardware rate-limiter
To display the hardware rate limit configuration and statistics, use the show hardware rate-limiter command.
show hardware rate-limiter {access-list-log [module module]| copy [module module]| f1 {rl-1 [module
module]| rl-2 [module module]| rl-3 [module module]| rl-4 [module module]| rl-5 [module module]}| layer-2
{l2pt [module module]| mcast-snooping [module module]| port-security [module module]| storm-control
[module module]| vpc-low [module module]}| layer-3 {control [module module]| glean [module module]|
glean-fast [module module] mtu [module module]| multicast {directly-connect [module module]|
local-groups [module module]| rpf-leak [module module]}| ttl [module module]}| module module| receive
[module module]}
Syntax Description
Specifies rate-limit statistics for access-list log
packets.
access-list-log
Specifies a module number. The range is from 1 to
18.
modulemodule
Specifies rate-limit statistics for copy packets.copy
Specifies the control packets from the F1 modules to
the supervisor.
f1
Specifies the F1 rate-limiter 1.rl-1
Specifies the F1 rate-limiter 2.rl-2
Specifies the F1 rate-limiter 3.rl-3
Specifies the F1 rate-limiter 4.rl-4
Specifies the F1 rate-limiter 5.rl-5
(Optional) Displays Layer 2 packet rate limits.layer-2
Specifies rate-limit statistics for Layer 2 Tunnel
Protocol (L2TP) packets.
l2pt
Specifies rate-limit statistics for Layer 2
multicast-snooping packets.
mcast-snooping
Specifies rate-limit statistics for Layer 2 port-security
packets.
port-security
Specifies rate-limit statistics for Layer 2 storm-control
packets.
storm-control
Cisco Nexus 7000 Series Security Command Reference
772
Show Commands
show hardware rate-limiter