feature cts
To enable the Cisco TrustSec feature, use the feature cts command. To revert to the default, use the no form
of this command.
feature cts
no feature cts
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature dot1x command.
The users can enable feature cts command even without having any license installed.
The Cisco TrustSec feature does not have a license grace period. You must install the Advanced Services
license to configure this feature.
Note
This command requires the Advanced Services license.
Examples
This example shows how to enable the Cisco TrustSec feature:
switch# configure terminal
switch(config)# feature cts
This example shows how to disable the Cisco TrustSec feature:
switch# configure terminal
switch(config)# no feature cts
Related Commands
DescriptionCommand
Enables the 802.1X feature.feature dot1x
Displays the Cisco TrustSec status information.show cts
Cisco Nexus 7000 Series Security Command Reference
317
F Commands
feature cts
To Next Page
Loading...
