Cisco Nexus 7000 Series - Set Dscp (Policy Map Class)

set dscp (policy map class)
To set the differentiated services code point (DSCP) value for IPv4 and IPv6 packets in a control plane policy
map, use the set dscp command. To revert to the default, use the no form of this command.
set dscp [tunnel] {dscp-value| af11| af12| af13| af21| af22| af23| af31| af32| af33| af41| af42| af43| cs1| cs2|
cs3| cs4| cs5| cs6| cs7| ef| default}
no set dscp [tunnel] {dscp-value| af11| af12| af13| af21| af22| af23| af31| af32| af33| af41| af42| af43| cs1|
cs2| cs3| cs4| cs5| cs6| cs7| ef| default}
Syntax Description
(Optional) Sets DSCP in a tunnel encapsulation.tunnel
Numerical value of CoS in the control plane policy
map. The range is from 0 to63.
dscp-value
Specifies assured forwarding 11 DSCP (001010).af11
Specifies assured forwarding 12 DSCP (001100).af12
Specifies assured forwarding 13 DSCP (001110).af13
Specifies assured forwarding 21 DSCP (010010).af21
Specifies assured forwarding 22 DSCP (010100).af22
Specifies assured forwarding 23 DSCP (010110).af23
Specifies assured forwarding 31 DSCP (011010).af31
Specifies assured forwarding 32 DSCP (011100).af32
Specifies assured forwarding 33 DSCP (011110).af33
Specifies assured forwarding 41 DSCP (100010).af41
Specifies assured forwarding 42 DSCP (100100).af42
Specifies assured forwarding 43 DSCP (100110).af43
Specifies class selector 1 (precedence 1) DSCP
(001000).
cs1
Specifies class selector 2 (precedence 2) DSCP
(010000).
cs2
Specifies class selector 3 (precedence 3) DSCP
(011000).
cs3
Cisco Nexus 7000 Series Security Command Reference
656
S Commands
set dscp (policy map class)