dot1x max-reauth-req
To change the maximum number of times that the Cisco NX-OS device retransmits reauthentication requests
to supplicants on an interface before the session times out, use the dot1x max-reauth-req command. To
revert to the default, use the no form of this command.
dot1x max-reauth-req retry-count
no dot1x max-reauth-req
Syntax Description
Retry count for reauthentication requests. The range
is from 1 to 10.
retry-count
Command Default
2 retries
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must use the feature dot1x command before you configure 802.1X.
This command does not require a license.
Examples
This example shows how to change the maximum number of reauthorization request retries for an interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# dot1x max-reauth-req 3
This example shows how to revert to the default maximum number of reauthorization request retries for an
interface:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# no dot1x max-reauth-req
Related Commands
DescriptionCommand
Enables the 802.1X feature.feature dot1x
Cisco Nexus 7000 Series Security Command Reference
193
D Commands
dot1x max-reauth-req
To Next Page
Loading...
