Cisco Nexus 7000 Series - Page 323

Usage Guidelines
You must use the feature eou command before you configure EAPoUDP.
This command does not require a license.
Examples
This example shows how to initialize all the EAPoUDP sessions:
switch# eou initialize all
This example shows how to initialize the EAPoUDP sessions that were statically authenticated:
switch# eou initialize authentication static
This example shows how to initialize the EAPoUDP sessions for an interface:
switch# eou initialize interface ethernet 1/1
This example shows how to initialize the EAPoUDP sessions for an IP address:
switch# eou initialize ip-address 10.10.1.1
This example shows how to initialize all the EAPoUDP sessions for a MAC address:
switch# eou initialize mac-address 0019.076c.dac4
This example shows how to initialize all the EAPoUDP sessions for a posture token:
switch# eou initialize posturetoken healthy
Related Commands
DescriptionCommand
Enables EAPoUDP.feature eou
Displays EAPoUDP information.show eou
Cisco Nexus 7000 Series Security Command Reference
297
E Commands
eou initialize