Cisco Nexus 7000 Series - Page 92

DescriptionCommand
Displays Cisco TrustSec configuration information
for interfaces.
show cts interface
Related Commands
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
You can use only IPv4 addressing with Cisco TrustSec.
This command requires the Advanced Services license.
Examples
This example shows how to configure Layer 3 Cisco TrustSec global mapping for an SPI and subnet:
switch# config t
switch(config)# cts l3 spi 3 10.10.1.1/23
This example shows how to remove Layer 3 global mapping for a subnet:
switch# config t
switch(config)# no cts l3 spi 10.10.1.1/23
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Displays the Layer 3 Cisco TrustSec mapping for SPI
values to IPv4 subnets.
show cts l3 mapping
Cisco Nexus 7000 Series Security Command Reference
66
C Commands
cts dot1x