Cisco Nexus 7000 Series - Page 142

Usage Guidelines
You must enable port security by using the feature port-security command before you can use the clear
port-security command.
This command does not require a license.
Examples
This example shows how to remove dynamically learned, secure MAC addresses from the Ethernet 2/1
interface:
switch# configure terminal
switch(config)# clear port-security dynamic interface ethernet 2/1
This example shows how to remove the dynamically learned, secure MAC address 0019.D2D0.00AE:
switch# configure terminal
switch(config)# clear port-security dynamic address 0019.D2D0.00AE
Related Commands
DescriptionCommand
Provides debugging information for port security.debug port-security
Enables port security globally.feature port-security
Shows information about port security.show port-security
Enables port security on a Layer 2 interface.switchport port-security
Cisco Nexus 7000 Series Security Command Reference
116
C Commands
clear port-security