Cisco Nexus 7000 Series - Page 201

This example shows how to remove an SXP peer connection:
switch# configure terminal
switch(config)# no cts sxp connection peer 10.10.1.1
This example shows how to configure the hold-time for the SXPv4 protocol for each connection.
switch# configure terminal
switch(config)# cts sxp connection peer 10.20.2.2 password default mode local speaker
hold-time 500
Related Commands
DescriptionCommand
Configures the default SXP password for the device.cts sxp default password
Configures the default SXP source IPv4 address for
the device.
cts sxp default source-ip
Enables the Cisco TrustSec feature.feature cts
Displays the Cisco TrustSec SXP peer connection
information.
show cts sxp connection
Cisco Nexus 7000 Series Security Command Reference
175
C Commands
cts sxp connection peer