Cisco Nexus 7000 Series - Page 207

The speaker calculates the keepalive time to one-third of the selected hold time by default, unless a different
keepalive time is locally configured.
Examples
The following example shows how to configure the hold time period of a listener device for a minimum of
300 seconds and a maximum of 500 seconds:
switch# configure terminal
switch(config)# cts sxp listener hold-time 300 500
Related Commands
DescriptionCommand
Enables Cisco TrustSec SXP on a device.cts sxp enable
Configures the hold time of a speaker device in an
SXPv4 network.
cts sxp speaker hold-time
Displays the status of all Cisco TrustSec SXP
configurations.
show cts sxp
Cisco Nexus 7000 Series Security Command Reference
181
C Commands
cts sxp listener hold-time