Cisco Nexus 7000 Series - Page 281

• mld-report—Multicast Listener Discovery Report
• nd-na—Neighbor discovery neighbor advertisements
• nd-ns—Neighbor discovery neighbor solicitations
• next-header—Parameter next header problems
• no-admin—Administration prohibited destination
• no-route—No route to destination
• packet-too-big—Packet too big
• parameter-option—Parameter option problems
• parameter-problem—All parameter problems
• port-unreachable—Port unreachable
• reassembly-timeout—Reassembly timeout
• redirect—Neighbor redirect
• renum-command—Router renumbering command
• renum-result—Router renumbering result
• renum-seq-number—Router renumbering sequence number reset
• router-advertisement—Neighbor discovery router advertisements
• router-renumbering—All router renumbering
• router-solicitation—Neighbor discovery router solicitations
• time-exceeded—All time exceeded messages
• unreachable—All unreachable
TCP Port Names
When you specify the protocol argument as tcp, the port argument can be a TCP port number, which is an
integer from 0 to 65535. It can also be one of the following keywords:
bgp—Border Gateway Protocol (179)
chargen—Character generator (19)
cmd—Remote commands (rcmd, 514)
daytime—Daytime (13)
discard—Discard (9)
domain—Domain Name Service (53)
drip—Dynamic Routing Information Protocol (3949)
echo—Echo (7)
exec—Exec (rsh, 512)
finger—Finger (79)
ftp—File Transfer Protocol (21)
Cisco Nexus 7000 Series Security Command Reference
255
D Commands
deny (IPv6)