Cisco Nexus 7000 Series - Page 332

Usage Guidelines
You must use the feature eou command before you configure EAPoUDP.
This command does not require a license.
The Cisco NX-OS software supports an eou revalidate command in global configuration mode. To use
an EXEC-level eou revalidate command in global configuration mode, include the required keywords.
Note
Examples
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate all
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate authentication static
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate interface ethernet 1/1
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate ip-address 10.10.1.1
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate mac-address 0019.076c.dac4
This example shows how to revalidate all the EAPoUDP sessions:
switch# eou revalidate posturetoken healthy
Related Commands
DescriptionCommand
Enables EAPoUDP.feature eou
Displays EAPoUDP information.show eou
Cisco Nexus 7000 Series Security Command Reference
306
E Commands
eou revalidate (EXEC)