Cisco Nexus 7000 Series - Page 405

Examples
This example shows how to enter IP access list configuration mode for an IPv4 ACL named ip-acl-01:
switch# configure terminal
switch(config)# ip access-list ip-acl-01
switch(config-acl)#
DescriptionCommand
Configures a deny rule in an IPv4 ACL.deny (IPv4)
Applies an IPv4 ACL to an interface as a router ACL.ip access-group
Applies an IPv4 ACL to an interface as a port ACL.ip port access-group
Configures a permit rule in an IPv4 ACL.permit (IPv4)
Displays all IPv4 ACLs or a specific IPv4 ACL.show ip access-lists
Enables collection of statistics for each entry in an
ACL.
statistics per-entry
Cisco Nexus 7000 Series Security Command Reference
379
I Commands
ip access-list