mac port access-group macacl
switchport
mac packet-classify
switch(config)# interface ethernet 2/3
switch(config-if)# ip port access-group ipacl in
ERROR: The given policy cannot be applied as mac packet classification is enable
d on this port
switch(config-if)#
Related Commands
DescriptionCommand
Applies a IPv4 ACL to an interface as a port ACL.ip port access-group
Applies a IPv6 ACL to an interface as a port ACL.ipv6 port traffic-filter
Configures an interface to operate as a Layer 2
interface.
switchport
Cisco Nexus 7000 Series Security Command Reference
497
M Commands
mac packet-classify
To Next Page
Loading...
