Cisco Nexus 7000 Series - Page 614

(Optional) Specifies the units for a burst in bytes.bytes
(Optional) Specifies the units for a burst in kilobytes.kbytes
(Optional) Specifies the units for a burst in megabytes.mbytes
(Optional) Specifies the units for a burst in
milliseconds.
ms
(Optional) Specifies the units for a burst in packets.packets
(Optional) Specifies the units for a burst in
microseconds.
us
Configures an action when the traffic conforms to the
specified rates and bursts.
conform
Specifies the drop action.drop
Specifies setting the class of service (CoS) value. The
range is from 0 to 7.
set-cos-transmit cos-value
Specifies the differentiated services code point
(DSCP) value for IPv4 and IPv6 packets. The range
is from 0 to 63.
set-dscp-transmit dscp-value
Specifies the precedence value for IPv4 and IPv6
packets. The range is from 0 to 7.
set-prec-transmit prec-value
Specifies the transmit action.transmit
Configures an action when the traffic exceeds the
specified rates and bursts.
exceed
Flags the packet on the CIR markdown map.set dscp dscp table cir-markdown-map
(Optional) Configures an action when the traffic
violates the specified rates and bursts.
violate
Flags the packet on the PIR markdown map.set dscp dscp table pir-markdown-map
Specifies the PIR rate.
pir pir-rate
(Optional) Specifies the extended burst size.
be
Extended burst size. The range is from 1 to
512000000.
extended-burst-size
Cisco Nexus 7000 Series Security Command Reference
588
P Commands
police (policy map)