Cisco Nexus 7000 Series - Page 669

This example shows how to revert to the default Cisco TrustSec SAP operation mode on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# cts dot1x
switch(config-if-cts-dot1x)# no sap modelist gmac
switch(config-if-cts-dot1x)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
Related Commands
DescriptionCommand
Enters Cisco TrustSec 802.1X configuration mode
for an interface.
cts dot1x
Enables the Cisco TrustSec feature.feature cts
Displays the Cisco TrustSec configuration for
interfaces.
show cts interface
Cisco Nexus 7000 Series Security Command Reference
643
S Commands
sap modelist