Cisco Nexus 7000 Series - Page 796

• lisp_inst—LISP Multitenant Policy
• netflow—NetFlow
• netflow_svi—NetFlow on SVI
• netflow_sampler—NetFlow Sampler
• netflow_sampler_svi—NetFlow Sampler on SVI
• otv—Overlay Transport Virtualization
• pacl—Port ACL
• pbr—Policy-Based Routing without statistics
• pbr_stats—Policy-Based Routing with statistics
• qos—Quality of Service
• racl—Router ACL without statistics
• racl_stats—Router ACL with statistics
• rbacl—Role-based ACL
• tunnel-decap—Tunnel Decap
• vacl—VLAN ACL without statistics
• vacl_stats—VLAN ACL with statistics
• wccp—Web Cache Communication Protocol
If the feature is not supported, the switch returns the following message:
This feature combination is not supported !
Examples
This example shows how to display a feature combination check on the ingress policy on a Layer 3 interface
with the following features—racl with no stats, pbr with stats, wccp, qos and netflow:
switch# show hardware access-list input interface feature-combo racl pbr_stats wccp qos
netflow
______________________________________________________________________________
Feature Rslt Type T0B0 T0B1 T1B0 T1B1
______________________________________________________________________________
RACL Interface Acl X
Netflow Acl X
QoS Interface Qos X
WCCP Interface Acl X
PBR Interface Stats Acl X
This example shows how to display a feature combination check on the ingress policy on a VLAN/SVI with
the following features—vacl with stats, racl on svi, pbr on svi, dhcp snoop on vlan and wccp:
switch# show hardware access-list input vlan feature-combo vacl_stat racl pbr dhcp wccp
______________________________________________________________________________
Feature Rslt Type T0B0 T0B1 T1B0 T1B1
______________________________________________________________________________
RACL Acl X
PBR Acl X
DHCP Acl X
SPM WCCP Acl X
VACL Stats Acl X
Cisco Nexus 7000 Series Security Command Reference
770
Show Commands
show hardware access-list feature-combo