Cisco Nexus 7000 Series - Page 885

last operation: enable
last operation status: success
This example shows how to display the RADIUS merge status:
switch# show radius merge status
Result: Waiting
This example shows how to display the RADIUS CFS session status:
switch# show radius session status
Last Action Time Stamp : None
Last Action : Distribution Enable
Last Action Result : Success
Last Action Failure Reason : none
This example shows how to display the RADIUS CFS status:
switch# show radius status
distribution : enabled
session ongoing: no
session db: does not exist
merge protocol status: not yet initiated after enable
last operation: enable
last operation status: success
This example shows how to display the pending RADIUS configuration:
switch# show radius pending
radius-server host 10.10.1.1 key 7 qxz123aaa group server radius aaa-private-sg
This example shows how to display the pending RADIUS configuration commands:
switch# show radius pending cmds
radius-server host 10.10.1.1 key 7 qxz12345 auth_port 1812 acct_port 1813 authentication
accounting
This example shows how to display the differences between the pending RADIUS configuration and the
current RADIUS configuration:
switch(config)# show radius pending-diff
+radius-server host 10.10.1.1 authentication accounting
Cisco Nexus 7000 Series Security Command Reference
859
Show Commands
show radius