Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
ADJUSTMENT Media Feed Related Checks and Adjustments 376
Confidential
4.13.6 Media Eject Correction Check & Adjustment
PAPER USED
Size: A4
Type: Archival Matte Paper
EXECUTION MODE
Normal Mode
STANDARD VALUE
Within ± 4
PROCEDURE
1. Turn the printer ON.
2. Set paper in the bypass feed unit, and press [Paper Feed ] to feed paper.
3. Start the Service Program and select Media Eject Correction Check &
Adjustment.
4. Click [Run].
The adjustment pattern will be printed.
5. Check that the pattern of the most closely aligned with the upper bar (without any
gap and not overlapping each other) among the printed patterns lies within the
standard range.
Within the standard value: Go to Step 8
Out of the range: Go to Step 6
6. Input the value for the pattern of most closely aligned with the upper bar (no gap
but not overlapping each other).
7. Click [Write], and return to Step 4.
8. Click [Finish].
9. Turn the printer OFF to complete the adjustment.
Figure 4-85. [Media Eject Correction Check & Adjustment] Screen
Figure 4-86. Check point
OKNG NG
<Overlapped>
<Aligned>
<Gapped>
To Next Page
Loading...
Need help?
General