Epson C11CA88001A1 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 229
Confidential
3.4.9 Ink System Mechanism
3.4.9.1 Ink Selector Assy
1. Discharge ink. (p358)
2. Remove the Front Cover. (p142)
3. Remove the Control Panel Cover. (p136)
4. Remove the Right Upper Cover. (p138)
5. Remove the Right Cover. (p139)
6. Remove the Left Cover. (p137)
7. Unlock the carriage, and move the CR Unit to the left end. (p124)
8. Remove the CR Cover. (p149)
9. Disconnect the connectors (CN105, CN106) from the SUB Board.
10. Disengage the hook, and remove the tube mounting plate.
11. Remove the three screws that secure the Ink Selector Assy.
A) Silver, Phillips, Bind P-tite M3x8: three pieces
Figure 3-161. Removing the Ink Selector Assy
C A U T I O N
Be sure to move the CR Unit to the left end before performing the
following steps. Performing the following step with the CR on the
platen may damage the Printhead.
CN105
Ink Selector Assy
CN106
A
Hook
Tube mounting plate
A
A

Epson C11CA88001A1 Specifications

General

Brand	Epson
Model	C11CA88001A1
Category	Printer
Language	English