Hioki 8841 - Operation Sequence (REC&MEM)

98
────────────────────────────────────────────────────
7.2 Operation Sequence (REC&MEM)
────────────────────────────────────────────────────
See Chapter 2
Settings on the STATUS1 screen
Press the
STATUS
key to display
the STATUS screen.
Preparation
Basic Settings
Advanced Settings
(Use this function, if necessary.)
Memory segmentation
See Section 15.1
Settings on the STATUS2 screen
Installation of the Unit
Turn on the power
Connect the inputs
Function
Select the recorder and memory
function.
Time axis range
(Recorder/Memory
waveform setting)
Determine the speed with which the
input signal waveform is captured.
Recording length
Determine the length of the data
sample for a single measurement.
Display function
Select the waveform data
(recorder/memory) on the waveform
display screen.
Display format
Select the format type for the
waveform display screen.
Print mode
(Waveform/
Numeric print)
Select the format, waveform, or
numerical value should be used to
output measured data and
calculation results.
Additional recording
Set whether additional recording is
required.
Print function
Select whether or not to print out
simultaneously with screen display.
Auto save function
Select whether or not to save the
waveform automatically after it is
captured.
Sequential save function
See
Section 7.3
7.2 Operation Sequence (REC&MEM)