319
────────────────────────────────────────────────────
14.4 SCSI Interface
────────────────────────────────────────────────────
14.4.3 Setting the SCSI ID
s1243
Function
display Meaning
##F3
:
Increases in number.
:
Decreases in number.
NOTE
Procedure
Screen: INTERFACE (SYSTEM4)
1. Press the SYSTEM key to display the INTERFACE
screen.
2. Move the flashing cursor to the
SCSI ID
item.
3. Use the function keys or Jog/Shuttle control to make
the setting.
■ 8841/42
Set the ID number of the 8841/42 on the SCSI bus.
The available value range is 0 to 7.
■ Target
Set the ID number of the MO drive, which will be connected to the 8841/42,
on the SCSI bus. The ID number of the internal MO drive (optional) is set
to 4. Therefore, if the internal MO drive has been mounted, the ID number
4 cannot be specified. The available value range is 0 to 7.
･ Do not set the SCSI ID of the 8841/42 and target to the same number.
･ When "SCSI" or "MO" is selected as the output destination, separate
destinations cannot be set for the auto save, parameter calculation result
save, and the COPY key output.
To Next Page
Loading...
