Hioki 8841 - Others

396
────────────────────────────────────────────────────
18.10 Others
────────────────────────────────────────────────────
Comment printing
Function, channel, Input range, Zero position, Trigger time, DIV and other
information can be printed.
Comment input function
Provided
Cursor measurement function
Time difference, voltage difference or number of cycles between cursors A
and B, voltage at each cursor, time from trigger
Scaling function
Specifiable for each channel
Display copy function
Provided
List/gauge functions
ON, OFF
Starting status backup
function
Provided
Auto setup function
When the power is turned on, settings and a waveform evaluation area stored
on a floppy disk can be automatically loaded.
Auto save function
Provided
Remote control
Start, stop and print control terminals (threshold value: 2.5 V approx. , active
low, or terminal short)
Auto-range function
Provided, selects optimum time axis and measurement range for input
waveform
VIEW function
Relative positions of displayed data within recording length is shown
When memory segmentation is used, usage condition of each block is shown.
On-line help
An explanation of the display screen or the item currently selected by the
cursor appears.
Key lock function
Locks all keys except the KEY LOCK key
LCD back lighting
ON, OFF (with the auto OFF function) (auto OFF time can be selected 1 to
30 min)
List print function
Settings output after waveform data print.
Output by pressing the PRINT key other than on display screen.
Logic display
On/off for each bits, The comments can be input
Vernier function
Input voltage can be minutely adjusted to the desired value.
Direct channel setting
Settable using the TIME/DIV key
The range position of direct input unit can be set by using the knob.
Level monitor function
Provided
18.10 Others