Hioki 8841 - System Reset; List System Configuration

279
────────────────────────────────────────────────────
12.6 INITIALIZE Screen
────────────────────────────────────────────────────
12.6.3 System Reset
12.6.4 List System Configuration
NOTE
・Resets all settings (except communication settings; GP-IB, RS-232C, SCSI,
LAN) the factory default values.
・The same effect can be achieved by turning power to the unit on while
holding down the
STOP key.
Procedure
1. Move the flashing cursor to the SYSTEM RESET item, and make the setting.
2. Press the (exec) function key.
All Reset:
To return all settings including communications settings to the original
factory settings, turn on power while holding down both the START key and
STOP key.
・The programmed optional configurations and software versions are
displayed.
・You can also view each system configuration from the opening screen.
Procedure
1. Move the flashing cursor to the SYSTEM VERSION item, and make the
setting.
2. Press the (exec) function key.
s-1064
The 8946 4ch ANALOG UNIT is designed for use with the 8841. If this
channel is used with the 8842 powered on, "ERR" appears in the opening
screen, indicating that the position at which the channel is connected is
incorrect, while the system configuration list screen displays "none."