Hioki 8841 - Real Time Print

305
────────────────────────────────────────────────────
13.6 Printing Procedure
────────────────────────────────────────────────────
13.6.3 Real Time Print
s1163
NOTE
The input waveform and data are printed out continuously in real time. (in
recorder and RMS recorder functions, recorder waveform in REC&MEM)
Procedure
Screen: STATUS (REC, RMS), STATUS1 (recorder waveform
in REC&MEM)
1. Press the STATUS key to display the STATUS screen.
2. Move the flashing cursor to the printer item.
3. Use the function keys, and select ON.
4. When measurement starts, waveform appears on
screen and printout starts.
･ At a time axis range setting of 200 ms/DIV or faster,
the waveform data will be printed out later.
(See Section 18.5)
･ While the printer always outputs the data at the
measurement magnification in recording mode, the
waveform on the screen is reduced in size at the ratio
shown below, depending on the time-axis range.
(REC)
50 ms/DIV×1/2, 20 ms/DIV ×1/10
(Recorder waveform in REC&MEM)
100 ms/DIV×1/2, 50 ms/DIV×1/5,
20 ms/DIV×1/10
･ With REC&MEM waveforms, real-time printing
cannot be selected in the time axis range of 20 to
200 ms/DIV.