Hioki 8841 - Page 134

110
────────────────────────────────────────────────────
7.3 STATUS Settings (REC&MEM)
────────────────────────────────────────────────────
Function
display
Meaning
:
1 block save of recorder data
:
1 block save of memory data
:
All block save both recorder and memory data
NOTE
7. Select the item to be stored.
8. Set the file name. For the input method, refer to Section 9.9.3.
When using auto-save, a number is appended to the name you specify as the
file name. This then becomes the file name. If you start procedures before
specifying a file name, AUTO is automatically enabled.
File names cannot contain the characters +, -, ], or [. Please note that file
names containing these characters will not be saved.
･
File names consist of 8 characters (or 4 double-byte characters). With auto-
save, since numbers are attached to the end of file names, long file names
are truncated when this number is appended to the end of the file name.
･
When automatic storage is selected for both recorder and memory data,
automatic storage is activated (an index file is created). If only recorder or
memory is set for storage, 1 block save is performed.
･
When auto-save is enabled, the storage channel cannot be selected. Data for
the channel for which the waveform is displayed is saved. For details on
auto saving file name, refer to Section 14.7.
･
When the recording length of the recorder is set to "CONT.", the auto-saving
cannot be made a setting.
･
When cursor A and B are enabled, partial saving is executed. However,
when All block save is selected, the partial saving cannot be executed.
･
If additional recording is enabled, only newly acquired waveforms are saved.
Even when A and B cursors appear on the screen, no partial save is
performed.
･
The same media is used for both the recorder and memory. Separate media
cannot be selected.
･
During automatic storage, if the STOP key is pressed to interrupt
measurement, waveforms taken prior to the interruption are stored
automatically.
･
The directory and the number of files that can be stored in the directory are
limited. For details, see Section 14.7.
･
When "COMMUNI" (communications) is selected as Media, Storage Method
and Type are not displayed.