Hioki 8841 - Page 21

vii
────────────────────────────────────────────────────
Notes on Use
────────────────────────────────────────────────────
WARNING
Installation Environment
To avoid electric shock, do not allow the product to get wet, and do
not use it when your hands are wet.
Grounding the Unit
The unit is constructed so as to be connected to a ground line via a
three-core power cord that is supplied with the unit. In order to
avoid electric shock, connect the unit to a properly grounded (3-pin)
outlet using the power cord provided.
Before Powering on
Check that the power supply is correct for the rating of the unit.
(The AC fuse is integrated in the unit.)
Usage Precautions for the Internal MO Drive (option)
Please do not attempt to disassemble the MO drive.
Laser radiation can be emitted when the MO drive is open. Avoid
looking directly into the laser when the MO drive is open. Maximum
laser output is 50 mW (at 685 nm, pulsed).
A laser warning label is attached to the bottom of the 8841/42 Unit.
Refer to Section 1.2, "Identification of Controls and Indicators" for
the label location.
CAUTION
Installation Environment
This product should be installed and operated indoors only, between 5
o
C
to 40
o
C and 35% to 80%RH.
This product is not designed to be entirely water- or dust-proof. To avoid
damage, do not use it in a wet or dusty environment.
Do not store or use the product where it could be exposed to direct
sunlight, high temperature or humidity, or condensation. Under such
conditions, the product may be damaged and insulation may deteriorate
so that it no longer meets specifications.
Using a printer
Using the printer in a high-temperature or high-humidity environment
should be avoided at all costs. This can seriously reduce the printer life.
Using the connecting cables
Use only the specified connection cable. Using a non-specified cable
may result in incorrect measurements due to poor connection or other
reasons.
Recording paper
This unit uses a thermal printer. The recording paper supplied has
characteristics finely tuned for use with the printer.
Using recording paper of a different specification may not only result in
impaired printing quality, but even prevent the printer from operating.
Always use the HIOKI specified product.
Printing is not possible if the recording paper is loaded wrong-side up.
(Refer to Section 2.8, "Loading Recoding Paper.")