Hioki 8841 - Page 275

251
────────────────────────────────────────────────────
11.2 Using the A
･
BCursors
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
NOTE
･
When the
A
･
B CSR select key is used to activate the A
･
B cursor mode, the
trace cursor can be used, also if it was set to OFF.
･
Trace cursor can not be used on the X-Y CONT recorder.
･
A
･
B cursor measurements are enabled even if the line cursor (vertical) or
trace cursor are off the screen. When the cursor is set to A&B and either the
A or B cursor is moved, both A and B cursors are shifted onto the screen.
･
The VIEW
key can be used to check the cursor position within the total
recording length.
･
Only channels for which a waveform is being displayed can be specified.
･
By specifying a different channel for the A and B cursors, a potential
difference between the waveforms in the respective channels can be
determined.
･
When the cursor is moved to the edge of the screen, the waveform is
scrolled.
･
If turning the the Shuttle control fully and holding the control for about five
seconds, the indication "auto scroll" appears on the function key display and
the waveform continues to scroll even if releasing the control. Auto-scroll is
canceled by pressing any key.
･
Even if the one of the cursors A and B is out of the screen, the measurement
between cursors can be made.