Hioki 8841 - Page 297

273
────────────────────────────────────────────────────
12.5 INTERFACE Screen (SYSTEM 4)
────────────────────────────────────────────────────
Preparations for Setting Parameters
When connecting to an existing network, the following parameters must be
set up. Ask the administrator (department) of the network system to assign
the following in advance:
_______________________________________________________________
DHCP: Used/not used
Host name and address of the 8841/42
Host name (up to 12 characters): _____________
IP address: __.__.__.__
Subnet mask: __.__.__.__
(When using DHCP, the IP address and subnet mask are not needed.)
DNS setting
DNS: Used/not used
IP address (when using DNS): __.__.__.__
(The setting that can be obtained from DHCP has priority.)
Gateway
Gateway: Used/not used
IP address (when using gateway):__.__.__.__
(The setting that can be obtained from DHCP has priority.)
TCP/IP Port No.: __X (default: 880X)
(Specify the three leftmost digits of the four digits. Numbers 0 to 9 in the
least significant digit are used by the 8841/42 or reserved. Specify the port
No. when default numbers 8800 to 8809 are not available.)
_______________________________________________________________
When setting up a network when only using a PC and recorders, not
connecting to an existing network, for example, set the parameters as shown
below.
IP address of PC: 192.168.0.1
IP address of 1st recorder: 192.168.0.2
2nd: 192.168.0.3
3rd: 192.168.0.4
4th: 192. 168.0.5
Host name: Enter the desired name (each host name must
be unique).
Subnet mask: 255.255.255.0
Gateway: OFF
DHCP: OFF
DNS: OFF
Port No.: 880x