275
────────────────────────────────────────────────────
12.5 INTERFACE Screen (SYSTEM 4)
────────────────────────────────────────────────────
Gateway ON/OFF and IP Address
Set the default gateway (default router).
Turn this ON and specify the IP of the device serving as a gateway when the
8841/42 communicates with a device (PC) on a network other than its own
network. When the PC is on the same network, use the default gateway of
the PC. When the 8841/42 is connected one-to-one with a PC or both are
connected to the same hub, a gateway is not necessary. Turn it off.
When DHCP is ON, any gateway information obtained from DHCP has
priority.
DNS ON/OFF and IP Address
Set DNS.
The IP address is a series of numbers that may be difficult to remember.
Thus, it would be easier to use a name to represent the address.
In a network with a server that searches IP addresses from names, you can
request this server to look up an IP address from a name and thus specify a
device by name and not by address.
There are two such servers: DNS and WINS. The 8841/42 only supports
DNS. However, these units cannot perform the dynamic registration of
names and IP addresses with DNS.
When DNS is ON, you can specify a device you communicate with by using
a name.
When DHCP is ON, any DNS information obtained from DHCP has priority.
Data Acquisition Server IP and Name
Specify the PC that runs the 9333 LAN COMMUNICATOR, with which the
8841/42 communicates. This setting is required for acquiring data using the
9333 LAN COMMUNICATOR.
When specifying with the IP address (when not using DNS), use the IP
address of the PC.
When DNS is ON and you specify the PC with a name, set IP to 0.0.0.0,
enter the host name of the device for which data is being collected in the
name field. When the host name is "collect.hioki.co.jp," for example, do not
omit ".hioki.co.jp." Otherwise, your request may not be granted. (Note that
the part shown as ".hioki.co.jp" may vary depending on your network
environment.)
When acquiring data using the 9333:
To send measurement data (saved by using the Auto Save function) to the
9333, set Media on Status 1 screen to COMMUNI (LAN). (Real-time
transfer of measurement data is not available.)
To send an Auto Print image to the 9333, set Auto Print destination on
Status 1 screen to COMMUNI (LAN).
To send parameter calculation results to the 9333, set Result Save on
Status 3 screen to COMMUNI (LAN).
To send a screen image by using the COPY key, set Copy Destination on
System 4 screen to COMMUNI (interface).
To send a print image by using the PRINT key, set Output Destination on
System 4 screen to COMMUNI (interface).
To Next Page
Loading...
