295
────────────────────────────────────────────────────
13.4 Setting the SYSTEM Screen (printout)
────────────────────────────────────────────────────
NOTE
・ Setting the indent width (when external printer setting)
When the output destination is set to external printer, and data is printed in
the ×1.0 setting, the top of the waveforms may not be printed by some
printers. In this case, set the size to ×0.8. However, if you would still like
to print in the ×1.0 setting, adjust the indent width between 0 and 10 mm
to print either the upper or lower portion, whichever you consider more
important.
･ Even if the
PRINT key sets output to an external printer, auto-print and real-
time printing will be unavailable. Use the internal printer.
･ Refer to the printer operating manual for the control codes.
To Next Page
Loading...
