Hioki 8841 - Page 380

356
────────────────────────────────────────────────────
16.1 Waveform Parameter Calculation (MEM)
────────────────────────────────────────────────────
s1411-3.4
Flashing cursor
Flashing cursor
:
Disable calculation
:
Average value
:
RMS value
:
Peak-to-peak value
:
Maximum value
:
Time to maximum
value
:
Minimum value
:
Time to minimum
value
:
Period
:
Frequency
:
Rise time
:
Fall time
:
Standard deviation
:
Area value
:
X-Y area value
Function
display
Meaning
:
Increase channel number.
:
Decrease channel number.
NOTE
(3) Select parameter calculation
1. Move the flashing cursor to the position shown in the
figure on the left.
2. Use the function keys to make the selection.
Up to four parameter calculations
(No. 1 - 4) can be set simultaneously.
(4) Set the calculation channel
1. Move the flashing cursor to the position shown in the
figure on the left.
2. Use the function keys or the Jog/Shuttle control to
make the selection.
･ The channels where no units are installed, a channel that deviates from the
set active channel range and channels for which display/record is set to
"OFF" will not be calculated.
･ When the X-Y area value is selected in parameter calculation, channels on
the X and Y axes should be specified. "ALL" cannot be selected.
･ Even if the display format is not the X-Y screen, the X-Y area value can be
selected.