24
────────────────────────────────────────────────────
2.8 Loading Recoding Paper
────────────────────────────────────────────────────
NOTE
5. Align the edges of the recording paper you
pulled out of the printer with the edges of the
recording paper set into the holder.
If the edges of the recording paper are not
aligned exactly, the paper will come out crooked
when printing.
6. Raise the head up/down lever.
7. Pull the recording paper to the outside through
the printer exit slot in the stock cover.
8. Close the stock cover, and finish by tearing off
the recording paper against the edge of the
printer exit slot.
･ Make sure that the recording papers positioned quite straight, if the
recording paper is slanted with respect to the roller there is a danger that
later a paper jam will occur.
･ Always put the unit in the head up condition when it is to be transported or
if it is to be stored for a long period of time. If the unit is left to lie in the
state where the roller is being subjected to pressure by the head, then the
roller may become deformed or the characters may become uneven.
･ Particularly care should be taken not to put the recording paper in back to
front by mistake, because if this happens the waveform cannot be drawn.
To Next Page
Loading...
