Hioki 8841 - Page 73

49
────────────────────────────────────────────────────
4.3 ST ATUS Settings (MEM)
────────────────────────────────────────────────────
NOTE
7. Set the file name. For the input method, refer to Section 9.9.3.
When using auto-save, a number is appended to the name you specify as the
file name. This then becomes the file name. If you start procedures before
specifying a file name, AUTO is automatically enabled.
File names cannot contain the characters +, -, ], or [. Please note that file
names containing these characters will not be saved.
･ File names consist of 8 characters (or 4 double-byte characters). With auto-
save, since numbers are attached to the end of file names, long file names
are truncated when this number is appended to the end of the file name.
･ When auto-save is enabled, the storage channel cannot be selected. Data for
the channel for which the waveform is displayed is saved.
･ When both auto-print and auto-save are enabled, auto-save usually takes
precedence. However, if roll mode is enabled, auto-print will execute first.
･ For details on connected SCSI device, refer to Section 14.4.
･ When cursor A and B are enabled, partial saving is executed.
･ During automatic storage, if the
STOP
key is pressed twice to interrupt
measurement, waveforms taken prior to the interruption are stored
automatically.
･ The directory and the number of files that can be stored in the directory are
limited. For details, see Section 14.7.
･ When "COMMUNI" (communications) is selected as Media, Storage Method
and Type are not displayed.