CCW-R-2**B INSTRUCTION MANUAL 6 FUNCTIONS OF THE OPERATION SCREENS
6-117
About zero adjustment
• Zero adjustment is performed while the [Power] key is on.
• Zero adjustment is performed for the weigh head displayed in blue.
• Zero adjustment cannot be executed for the weigh unit and dispersion unit simultaneously.
• When [Multi Dump Initiate] in [Pckr Intrlck Set] is set to [Sync], zero adjustment does not
operate without interlock signal from the packer. In this case, interlock the device with the
packer.
• Before starting zero adjustment for the weigh unit, products in the weigh hopper are
automatically discharged.
• In addition, check the span. (See the following.)
Span adjustment procedure
1. Place the span adjustment weight on the weigh
hopper for which span is to be adjusted.
• Normally the span adjustment weight is
200g. However, it may vary depending
on the specifications.
Fig.6-117 Weigh Hopper
2. Select the head to be adjusted.
X The selected heads are displayed in blue.
To adjust all heads, press the [All Head
SLCT/CLR] key .
Fig.6-118 [Weighing Adjst] Tab Screen
([Manual Adjustment] Screen)
To Next Page
Loading...
