4535 611 98931 iE33 Service Manual Page 112
CSIP Level 1 Installation: Peripheral Installations
The menu settings are listed in Ta bl e 5- 4 and are set using “To change the VCR menu settings”
on page 112. Enter the numerical code from Tabl e 5-4 to enter the settings listed. (The numeri-
cal codes will be displayed but the settings will not be.)
The hidden menu settings are listed in Table 5- 5. The settings are changed using “To change the
VCR hidden menu settings” on page 115.
NOTE When the system is shipped from the factory, the VCR is set to the English language. If
you want to set the VCR to another language, press the RESET button on the lower
rear corner of the VCR and cycle through the languages displayed on the VCR display.
➤ To change the VCR menu settings
1. Power up the VCR.
2. Press and hold Menu for at least two seconds to initiate the VCR display.
NOTE It is not possible to program the VCR using video loop-through capability as on previ-
ous systems.
3. Select items with JOG/ADJUST.
4. Select settings with FRAME/FIELD ENTER.
5. Change the settings with JOG/ADJUST.
6. Exit and save changes by pressing MENU.
To Next Page
Loading...