High Voltage SourceMeter Instrument Reference Manual Section 1:
2470-901-01 Rev. A / May 2019 1-3
• SCPI command reference: Contains programming notes and an alphabetical listing of SCPI
commands available for the 2470.
• Introduction to TSP operation: The basics of using Test Script Processor (TSP
®
) commands to
c
ontrol the instrument.
• TSP command reference: Programming notes and an alphabetical listing of TSP commands
available for the 2470.
• Frequently asked questions: Answers to commonly asked questions.
• Next steps: Sources of additional information.
• Common commands: Contains descriptions of IEEE Std 488.2 common commands.
• Status model: Describes the 2470 status model.
The PDF version of this manual contains bookmarks for each section. The manual sections are also
listed in the Table of Contents at the beginning of this manual.
For more information about bookmarks, see Adobe
®
Acrobat
®
or Reader
®
help.
Features
The 2470 offers the following features:
• One tightly-coupled instrument that combines capabilities from analyzers, curve tracers, and I-V
sy
stems at a fraction of their cost.
• Wide coverage — up to 1100 V / 1 A DC, 20 W maximum.
• Five-inch, high resolution capacitive touch screen GUI.
• 0.012% basic measure accuracy with 6½ digits.
• Source and sink (4-quadrant) operation.
• Four Quickset modes for fast setup and measurements.
• Context-sensitive help.
• Front-panel input banana jacks; rear-panel high-voltage input triaxial connections.
• SCPI and TSP
®
scripting programming modes.
• Front-panel USB 2.0 memory I/O port for transferring data, test scripts, or test configurations.
To Next Page
Loading...
Need help?
General
