To Next Page

To Previous Page

Section

14: TSP command reference 2470 High Voltage SourceMeter Instrument

Reference Manual

14-96 2470-901-01 Rev. A / May 2019

node[N].execute()

This function starts test scripts on a remote TSP-Link node.

Type TSP-Link accessible

Affected by Where saved Default value

Function

Yes (see Details)

Usage

node[N].execute("scriptCode")

The node number of this instrument (1 to 63)

scriptCode

A string containing the source code

Details

This command is only applicable to TSP-Link systems. You can use this command to use the remote

master node to run a script on the specified node. This function does not run test scripts on the

master node; only on the subordinate node when initiated by the master node.

This function may only be called when the group number of the node is different than the node of the

master.

This function does not wait for the script to finish execution.

Example 1

node[2].execute(sourcecode)

Runs script code on node 2. The code is in a string variable

called

sourcecode

Example 2

node[3].execute("x = 5")

Runs script code in string constant (

"x = 5"

) to set

equal

to 5 on node 3.

Example 3

node[32].execute(TestDut.source)

Runs the test script stored in the variable TestDut

(previously stored on the master node) on node 32.

Also see

tsplink.group (on page 14-269)

Tektronix Keithley SourceMeter 2470 Reference Manual

Other manuals for Tektronix Keithley SourceMeter 2470