Tektronix Keithley SourceMeter 2470 Reference Manual

Section
14: TSP command reference 2470 High Voltage SourceMeter Instrument
Reference Manual
14-286 2470-901-01 Rev. A / May 2019
Example
tspnet.tsp.abortonconnect = 0
Configure the instrument so that it does not
send an abort command when connecting to
a TSP-enabled instrument.
Also see
tspnet.connect() (on page 14-277)
tspnet.tsp.rbtablecopy()
This function copies a reading buffer synchronous table from a remote instrument to a TSP-enabled instrument.
Type TSP-Link accessible
Affected by Where saved Default value
Function No
Usage
table = tspnet.tsp.rbtablecopy(connectionID, "name")
table = tspnet.tsp.rbtablecopy(connectionID, "name", startIndex, endIndex)
table
A copy of the synchronous table or a string
connectionID
Integer value used as a handle for other tspnet commands
name
The full name of the reading buffer name and synchronous table to copy
startIndex
Integer start value
endIndex
Integer end value
Details
This function is only appropriate for TSP-enabled instruments.
This function reads the data from a reading buffer on a remote instrument and returns an array of
numbers or a string representing the data. The startIndex and endIndex parameters specify the
portion of the reading buffer to read. If no index is specified, the entire buffer is copied.
The function returns a table if the table is an array of numbers; otherwise a comma-delimited string is
returned.
This command is limited to transferring 50,000 readings at a time.
Example
times =
tspnet.tsp.rbtablecopy(testTspdevice,
"testRemotebuffername.timestamps", 1, 3)
print(times)
Copy the specified timestamps table for
items 1 through 3, then display the table.
Example output:
01/01/2015
10:10:10.0000013,01/01/2015
10:10:10.0000233,01/01/2015
10:10:10.0000576
Also see
None

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English