14: TSP command reference 2470 High Voltage SourceMeter Instrument
14-36 2470-901-01 Rev. A / May 2019
bufferVar.startindex
This attribute indicates the starting index in a reading buffer.
Type TSP-Link accessible Affected by Where saved Default value
Instrument reset
Power cycle
Usage
bufferVar.startindex = startIndex
Starting index of the buffer
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
Details
Use this attribute to find the starting index in a reading buffer.
Example
smu.measure.count = 6
smu.measure.read(test1)
print(test1.startindex, test1.endindex, test1.capacity)
Create a buffer named test1 with a capacity of 100 readings.
Set the measure count to 6.
Make measurements and store them in buffer test1.
Get the start index, end index, and capacity of test1.
Output:
Also see
bufferVar.endindex (on page 14-21)
buffer.make() (on page 14-12)
Reading buffers (on page 6-1)
Remote buffer operation (on page 6-25)
To Next Page
Loading...
Need help?
General
