Tektronix Keithley SourceMeter 2470 Reference Manual

2470
High Voltage SourceMeter Instrument Reference Manual Section 14:
TSP command reference
2470-901-01 Rev. A / May 2019 14-273
tsplink.line[N].state
This attribute reads or writes the digital state of a TSP-Link synchronization line.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Not applicable
Not applicable
tsplink.STATE_HIGH
Usage
lineState = tsplink.line[N].state
tsplink.line[N].state = lineState
lineState
The state of the synchronization line:
 Low: tsplink.STATE_LOW
 High: tsplink.STATE_HIGH
N
The trigger line (1 to 3)
Details
Use tsplink.writeport() to write to all TSP-Link synchronization lines.
The reset function does not affect the present states of the TSP-Link trigger lines.
Example
lineState = tsplink.line[3].state
print(lineState)
Assume line 3 is set high, and then the state
is read.
Output:
tsplink.STATE_HIGH
Also see
tsplink.line[N].mode (on page 14-271)
tsplink.writeport() (on page 14-276)
tsplink.master
This attribute reads the node number assigned to the master node.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
masterNodeNumber = tsplink.master
masterNodeNumber
The node number of the master node (1 to 63)
Details
This attribute returns the node number of the master in a set of instruments connected using
TSP-Link.

Tektronix Keithley SourceMeter 2470 Specifications

General

Brand	Tektronix
Model	Keithley SourceMeter 2470
Category	Measuring Instruments
Language	English